System Memory; Jumper Settings; Panel Power Select - DFI FS053 User Manual

Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.

System Memory

Important:
The Debug LED lights red until the operating system is being accessed. Power-off the
PC then unplug the power cord prior to installing any devices. Failure to do so will
cause severe damage to the motherboard and components.
DDR3L
Debug LED
Features
• 1GB/2GB SDRAM Memory Down
• Single Channel DDR3L 1600MHz
Chapter 2 Hardware Installation
Chapter 2

Jumper Settings

Panel Power Select

JP1 is used to select the power supplied with the LCD panel.
ON
1 2 3 4 5 6 7 8
DDR3L
10
Important:
Before powering-on the system, make sure that the power settings of JP1 match the
LCD panel's specification. Selecting the incorrect voltage will seriously damage the
LCD panel.
1
3
1-2 On: +3.3V
(default)
1
3
JP1
2-3 On: +5V
www.dfi.com