Chapter 3 - Software User Guide; Introduction; Check Board Type; Download Images To Emmc With Mfgtool - DFI FS053 User Manual

Chapter 3 - Software User Guide

► Introduction

FS053 platform is an embedded system with Yocto 1.8 preloaded on eMMC. Demo images are
supported under Yocto 1.8 and Android 5.1.1 environment.
► Revision Control
The system board of a specific revision — Rev. A or Rev. B — is only compatible with the soft-
ware images that correspond to its revision. It is strongly recommended against that a Rev. A
system be loaded with Rev. B images or vice versa. Failure in loading a compatible image onto
the system may result in malfunction and unexpected errors.

► Check Board Type

The CPU core type of the system board dictates which images and only which images can be
loaded. Identify which of the two core types the board is before proceeding — i.MX6 DualLite
CPU or i.MX6 Quad CPU.
FS053 DualLite SW5
Chapter 3 Software User Guide
Chapter 3
FS053 Quad SW5
21
► Loading Images

Download Images to eMMC with MFGTool

1. Set the finger switch SW5 to "Serial Downloader Mode": pins 7 on and 8 off.
ON
1 2 3 4 5 6 7 8
Boot Mode/Device Select
(SW5)
Pins 1, 2, 5, 6, 7 ON
2. Plug in the Micro USB cable to your PC and power-on the FS053.
Important:
The adapter output voltage is 9~36V for FS053.
Micro USB Cable
+
-
www.dfi.com