Vacuum Filtration Station Task Parameters - Agilent Technologies Bravo Platform User Manual

Vacuum Filtration Station task parameters

About this topic
Parameter description: Assemble Vacuum task
Bravo Platform User Guide
This topic describes the task parameters for the following:
•
Assemble Vacuum task. Directs the robot to pick up the Vacuum Filtration
Station components from designated deck locations and stack them in the
order you specify.
•
Disassemble Vacuum. Directs the robot to remove components from the
Vacuum Filtration Station and place them back at the locations specified in the
Assemble Vacuum task.
•
Move and Filter Plate. Moves a plate to the Vacuum Filtration Station and turns
on the vacuum.
To use the Assemble Vacuum and Disassemble Vacuum tasks, you must first set
the Robot gripper offset value for the labware that will be placed on the Vacuum
Filtration Station during a protocol run. You set the offset in the Labware Editor.
To run the Vacuum Filtration Station tasks, see
Diagnostics" on page 100.
Parameter
Assembly order
Vacuum Filtration base
E Diagnostics quick reference

Vacuum Filtration Station task parameters

"Performing a task using Bravo
Description
The order, from bottom to top, in which you want
to stack the station components. The selections
are:
•
Base-Collection plate-Filter plate-Collar
(configuration A)
•
Base-Collection plate-Collar (configuration B)
•
Base-Collar (configuration C)
For details, see "Installing and setting up a
Vacuum Filtration Station" on page
The location of the Vacuum Filtration Station
base.
114.
261