Agilent Technologies Bravo Platform User Manual page 159

A Accessories and platepads
Installing and setting up a Nested Rack Insert
Installing and configuring the Nested Rack Insert
148
To install the Nested Rack Insert:
1
On the Bravo deck, locate the platepad where you plan to do tips-on and tips-off
tasks. Place the Nested Rack Insert on the platepad, making sure to align the
crosshairs on the insert (1) directly above the platepad crosshairs.
2
To secure the Nested Rack Insert, use a 1.5 mm hex wrench to tighten the platepad
screw (2).
1
To configure the Nested Tip Rack Insert:
1
In Diagnostics, click the Profiles tab, and verify that the correct profile is initialized.
2
Click the Configuration tab.
3
In the Location is configured as list, select Accessory. The Accessories Wizard
appears.
4
Follow the instructions in the Accessories Wizard to:
a
Specify the Location of the installed insert.
Note: Your selection in the Accessories Wizard overrides the default
selection in the Configuration tab.
b
Choose the Nested Tip Rack Insert.
5
When the configuration message appears, click Yes to initialize the accessory and
move the teachpoint to a safe height.
6
Set the teachpoint for the Nested Rack Insert using the same procedure that you
would for a platepad.
2
Bravo Platform User Guide