Cardiac Science Burdick 8500 Product Safety Manual page 8

Product Safety and Setup
Electrical Safety
This product is intended to be operated from a mains power
source of nominally 100 to 230V, 47 to 63 Hz and Maximum
AC Power consumption: 35 VA.
DANGER: Explosion hazard!
Operating electrical equipment in an environment containing
explosive gases can trigger an explosion. Use this equipment only
in a well-ventilated, ambient environment. Do not use the device
in the presence of flammable anesthetics, in an explosion-
endangered, or oxygen-enriched environment. The device is not
classified AP or APG.
WARNING! Electrical shock
Before plugging this device into any power source, ensure the
label on the rear panel of the ECG device displays the appropriate
voltage range for your location.
WARNING! Electrical hazard
Improperly grounded equipment has the potential to cause
electrical shock. Use only the power cords supplied by Cardiac
Science and plug the system into a properly grounded power
outlet only. Do not use ungrounded adapters or extension cables.
WARNING! Electrical hazard
Improperly grounded equipment has the potential to cause
electrical shock. Do not use the ECG device if there is any question
about the integrity of the protective ground conductor
arrangement. Immediately remove the device from AC power
until the grounding issue have been resolved.
WARNING: Electrical shock
Damaged power cords have the potential to cause electrical
shock. Before using the system, check for power cords that may be
broken or frayed. Do not use any system with damaged power
cords and remove power from a system with damaged power
cords. Do not tamper with the grounding pin on the plug.
8
70-01047-01 B