Cardiac Science Burdick 8500 Product Safety Manual page 42

Product Safety and Setup
Table 3: Electromagnetic immunity
Immunity IEC 60601 test
test level
Electrostatic ±6 kV contact
discharge (ESD)
±8 kV air
IEC 61000-4-2
Electrical fast ±2 kV for power
transient/burst supply lines
IEC 61000-4-4 ±1 kV for input/
output lines
Surge ± 1kv line(s) to line(s)
IEC 61000-4-5 ±2 kV line(s) to earth
Voltage dips, <5% U
short (<95% dip in U
interruptions for 0,5 cycle
and voltage
40% U
variations on
(60% dip in U
power supply
for 5 cycles
input lines
70% U
IEC 61000-4-11
(30% dip in U
for 25 cycle
<5% U
(<95% dip in U
for 5 sec
Power frequency 3 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE 1: U is the a.c. mains voltage prior to application of the test level.
T
42
Compliance
level
±6 kV contact
±8 kV air
±2 kV for power
supply lines
±1 kV for input/
output lines
±1kv differential
mode
±2 kV common mode
<5% U
T
) (<95% dip in U
T
for 0,5 cycle
40% U
T T
) (60% dip in U
T
for 5 cycles
70% U
T T
) (30% dip in U
T
for 25 cycle
<5% U
T
) (<95% dip in U
T
for 5 sec
3 A/m
Electromagnetic
environment - guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30%.
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be that of a
typical commercial or hospital
environment.
Mains power quality should be typical of a
T
) commercial or hospital environment.
T
If the Burdick 8300/8500 user requires
continued operation during power mains
) interruptions, then the Burdick 8300/8500
T
must be powered from an uninterruptible
power supply or a battery.
)
T
T
)
T
Power frequency magnetic fields should
be at levels characteristic of a typical
location in a typical commercial or hospital
environment.
70-01047-01 B