Adjusting The Carrier Roller Pressure - DURKOPP ADLER 827 Service Instructions Manual

To adjust the lower end position:
1. Loosen the counternut (5).
2. Turn the threaded pin (6).
3. Tighten the counternut (5).

15.4 Adjusting the carrier roller pressure

Fig. 51: Adjusting the carrier roller pressure
(1) - Cylinder
To adjust the carrier roller pressure:
1. Loosen the screw (2).
2. Move the cylinder (1).
3. Tighten the screw (2).
Order
Proceed by adjusting the upper end position of the carrier roller
stroke ( p. 69).
70
• lifting: Turn the threaded pin (6) clockwise
• lowering: Turn the threaded pin (6) counterclockwise
②
• To reduce pressure: Slide the cylinder (1) to the back
• To increase pressure: Slide the cylinder (1) to the front
①
(2) - Screw
Service Instructions 827/827-M - 01.0 - 05/2019
Puller