Adjusting The Electropneumatic Switching Of The Carrier Roller - DURKOPP ADLER 827 Service Instructions Manual

Programming
19.1 Adjusting the electropneumatic switching of the carrier
To adjust the electropneumatic switching of the carrier roller:
1. Press the
2. Enter the parameters for the automatic stitch loosening device:
3. Press the
4. Enter the desired mode:
5. Press the
6. To switch to sewing mode, press the
For additional parameter settings, refer to  Parameter list.
Service Instructions 827/827-M - 01.0 - 05/2019
roller
button.
t 14 00.
• Use A+ to set the value to t.
• Use B+ to set the value to 14.
• Use D+ to set the value to 00.
button.
• Use D+ to enter the value 0: do not raise
• Use D+ to enter the value 1: raise on sewing foot lift
• Use D+ to enter the value 2: raise on bartack
• Use D+ to enter the value 3: raise on bartack and sewing foot lift
button to save the setting.
button.
91