4. Loosen the threaded pins (5).
5. Turn the stroke eccentric (4) such that the walking foot touches down
Important
When doing so, ensure not to move the stroke eccentric (4) laterally on
the axle.
6. Tighten the threaded pins (5).
7. Unscrew the threaded pin (6) far enough so that there is no longer any
12.3 Adjusting the sewing foot pressure
The adjusting wheel at the top left of the machine arm determines
the pressure for the sewing feet on the sewing material. The pressure
can be adjusted continuously by turning the adjusting wheel.
The correct pressure depends on the sewing material:
• Lower pressure for soft materials
• Higher pressure for durable materials
Fig. 45: Adjusting the sewing foot pressure
(1) - Adjusting wheel for the sewing foot
To adjust the sewing foot pressure:
1. Turn the adjusting wheel for the sewing foot pressure (1):
60
on the feed dog when the handwheel is in the 95° position.
contact with the clamp.
①
pressure
• greater pressure: turn clockwise
• lower pressure: turn counterclockwise
Sewing Feet
Service Instructions 867 - 04.0 - 10/2019