Notes On Work Safety - HSM SP 5080 Operating Manual

1.3

Notes on work safety

Please pay particular attention to the following notes on work safety:
– The SP 5080 shredder press combination has been safety-tested by an accredited testing
station.
Nevertheless, incorrect operation and misuse can result in:
• the health or life of the operator
• the machine and other valuable equipment
• the effi cient operation of the shredder
– The SP 5080 shredder press combination has been built with the most up-to-date
technology. However, the machine can be dangerous if improperly used, even by trained-
staff, or if used for purposes other than those for which it was designed.
– The operation of the shredder press combination is always subject to local safety and acci-
dent prevention regulations.
– The employer must observe and comply with the "minimum safety and health requirements-
for the use of work equipment by workers at work". Machinery Directive 2009/104/EC
– The shredder press combination may not be operated by anyone under 16 years of age.
– All those charged with installation, assembly, disassembly, start-up, operation, inspection,
maintenance or repair of the baling press must have fi rst read and fully understood the en-
tire operating manual, paying particular attention to the "Safety" section.
– The shredder press combination may only be operated, serviced and repaired by authorised,
trained staff. These staff must have been given special instructions on any dangers which
may possibly arise.
– Areas of personal responsibility for installation, assembly, re-assembly, set-up, operation and
maintenance must be clearly defi ned and strictly adhered to, in order to avoid confusion
which might compromise safety.
– When carrying out installation, disassembly, re-assembly, maintenance, operation, adjust-
ment and maintenance work always observe the shut-down procedures described in the
operating manual. Never perform this kind of work on the machine unless it is fully shut
down.
– Before performing such tasks make sure the drives and additional mechanisms of the baling
press cannot be switched on unintentionally. Turn the main switch to the "0" position and se-
cure it. Pull out the power plug.
– Before starting the machine after repairs, make sure all protective devices are in place.
04/2013
2.990.999.120_en
SP 5080
9