Proper Use - HSM SP 5080 Operating Manual

SP 5080
1.4

Proper use

The SP 5080 shredder press combination is intended solely for shredding and pressing
paper and cardboard. The robust cutting unit is unaffected by staples and paper clips and
is even suitable for the destruction of whole volumes of fi les and folders. Excluding other
types of materials.
Mode of operation:
The above mentioned material is fed into the Shredder. The shredded material falls
through the discharge chute of the shredder directly into the hopper of the press. The
press cycle is initiated by a light barrier in the hopper when it has been fi lled to a certain
level. The press ram is extended and pushes the material into the press chamber, where
it is compacted. The shredder continues to run during the press cycle. As soon as the
bale has reached a certain length, it has to be ejected into a gusseted bag. Thereafter
pressing can continue.
Any other use is considered improper. The manufacturer accepts no liability for damage
resulting from improper use - the operator carries sole responsibility for such use.
Proper use also includes carrying out installation, assembly, disassembly, start-up, operation
and maintenance work as prescribed by the manufacturer. The baling press may
only be operated, serviced and repaired by staff who are familiar with these regulations
and aware of the dangers.
The shredder press combination may only be operated by authorised, trained staff. Do
not carry out any tasks which may endanger your safety while operating the machine.
The relevant accident prevention regulations and any other generally recognised health
and safety standards must also be observed.
2.990.999.120_en
11
04/2013