Description Of The Sounds; Stand-By Mode - Dentsply Sirona X-SMART IQ Directions For Use Manual

Step by Step Instructions

6.6.1.3 Description of the Sounds

Mode
Device running in
continuous
rotation
Device running in
reciprocating
motion
Battery charge
level
Motor START/
STOP button
Multifunction
button

6.6.1.4 Stand-by Mode

When the motor handpiece is not used for a certain period of
time, it enters stand-by mode as described below.
Mode
Device active
Stand-by mode 1
(inactive for 35 s)
Stand-by mode 2
(inactive for
30 min)
32/88 T US XSIQ DFU WEB / Rev.00 (based from T US XSIQ DFU WEB / Rev.05 / 07-2017) / 09-2018
Intermittent sound when:
• The device is rotating in reverse.
• The torque measured is about 75% over the defined
torque.
Intermittent sound when:
• The instrument is subject to increased friction.
• After switching to forward rotation.
• One short beep when the battery charge level is
low.
• Three-second beep when the battery charge level is
critical.
A short beep when pressing the button.
A short beep when pressing the button.
LED description
All LEDs ON.
All LEDs ON.
Motor START/
STOP button
blinking blue
every 3 s.
All LEDs OFF.
Description
Application
display
®
Bluetooth ON,
device visible on
status bar.
®
Bluetooth ON,
device visible on
status bar.
®
Bluetooth OFF,
device not
visible on status
bar.
Wake-up action
None.
(Device ready
to be used).
Pick-up the
motor
handpiece.
Press the
multifunction
button.