Configuring Freely Configurable Channels (Parameter Overview - Diq) - Siemens SIMATIC CFU Commissioning Manual

Commissioning
8.8 Commissioning (offline)
The further steps are shown using the setting of the PROFINET node IP address on the CFU
as an example:
1. Select the menu command Edit > Object Properties ... .
2. Enter a unique designation for the interface module in the "Device name" entry field of the
"General" tab.
The unique designation is imperative for the PROFINET node.
Note
Device name
You must also enter this device name locally on the PROFINET device.
You can find additional information about this in section "Assigning device names with
existing configuration from HW Config (Page 78)".
3. Click the "Ethernet" button in "Node in PROFINET IO System" section.
The "Properties - Ethernet interface ..." dialog box is opens.
4. Enter the IP address of the CFU as a device on PROFINET IO in the "Parameters" tab.
Assign a unique IP address in the PROFINET IO system.
5. Select the network in the "Subnet" section.
If a subnet has not yet been created: Click the "New" button.
Further settings are not required for the CFU.
6. Click the "OK" button to apply the settings.
Parameters for the PROFINET IO system
You can find additional information in the STEP 7 online help on parameterizing the PROFINET
IO system in the "General" tab.
8.8.3.2

Configuring freely configurable channels (parameter overview - DIQ)

Setting parameters
The following parameter tables contain an overview of all the parameters of the freely
configurable channels of the Compact Field Unit.
Tab in HW Config
Tab
General
94
Settings in the "Properties..." dialog box of the DIQ area
You can enter a name for the DIQ area.
Commissioning Manual, 08/2019, A5E39252870-AD
②
SIMATIC CFU