Cfu Pa: Assigning Parameters To The Profibus Pa Master (Parameter Overview - Fb M) - Siemens SIMATIC CFU Commissioning Manual

8.8.3.3 CFU PA: Assigning parameters to the PROFIBUS PA Master (parameter overview - FB
M)
Objects in HW Config
Table 8-4
Tab
General
Table 8-5
Tab
General
Addresses
Parameters
Table 8-6
Tab
General
Addresses
Setting parameters
1. Open HW Config.
2. Select the CFU PA.
3. In the index list, double-click the object slot (e.g. Parameters + Diagnosis).
The dialog box opens.
4. Select the corresponding tab (e.g. "Parameters").
Note:
If PCS 7 is used, the Engineering System applies a correct parameter assignment to the
addresses. The name in the General tab can be applied unchanged.
5. Make the required settings.
6. Download the parameter assignment to the CFU PA.
SIMATIC CFU
Commissioning Manual, 08/2019, A5E39252870-AD
FB M
Settings in the "PROFIBUS PA Master" dialog box
You can enter a name for the PROFIBUS PA Master.
Parameters + Diagnosis
Settings in the "Properties..." dialog box for Parameters + Diagnosis
Name of the parameter interface of the PROFIBUS PA Master
Setting diagnostic address
● Displaying DPV0 alarms on CFU PA LEDs (Page 98)
● Comparing TAGs (Page 98)
● Service interface (Page 124)
● Manual field device integration (Page 99)
Status + Notifications
Settings in the "Properties..." dialog box for Status + Notifications
Name of the status interface of the PROFIBUS PA Master
Addresses used internally (these must not be changed)
Commissioning
8.8 Commissioning (offline)
97