Siemens SIMATIC CFU Commissioning Manual page 93

Basic procedure
1. In HW Config, select the object (see the following figure, e.g. for CFU PA) that is to have
parameters assigned to it.
All objects on the CFU:
SIMATIC CFU
Commissioning Manual, 08/2019, A5E39252870-AD
①
PROFINET IO system (fieldbus system)
②
Setting the CFU parameters for PROFINET IO:
③
Slot 0 of the CFU: Parameters for the CFU (Slot 0)
④
Slot 0/ X1: Parameters for PROFINET IO (PROFINET IO interface of CFU X5)
⑤
Slot 0/ X1 P1 R: Parameters for BusAdapter (port 1 of the PROFINET IO interface X1)
⑥
Slot 0/ X1 P2 R: Parameters for BusAdapter (port 2 of the PROFINET IO interface X1)
Commissioning
8.8 Commissioning (offline)
1
2
3
4
5
6
1
93