Table of Contents
Advertisement
ð
3.4 DMX ADDRESSING
To set DMX addressing follow the instructions below:
• Press the MENU button to enter the menu mode.
• Use the buttons UP/DOWN to select Connect. Press the ENTER button to confirm.
• Press the UP/DOWN buttons to select DMX Address. Press the ENTER button to confirm.
• Press the UP/DOWN buttons to select the desired value 001-512. Press the ENTER button to confirm.
• Press repeatedly the MENU button to return the menu mode.
To able to operate the SOLAR48Q with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the SOLAR48Q. The other functions of the light effect panel are
then automatically assigned to the following addresses.
Several units may be interconnected; follow the instructions below:
1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 16).
Number of
Start address
DMX chan-
(example)
nels
5
33
7
33
10
33
17
33
22
33
SOLAR48Q
Static
ð
ð
Manual color
DMX Address
Next possible start
occupied
address for unit No. 1
33-37
33-39
33-42
33-49
33-54
R
G
B
W
GB
RB
RG
RGB
RW
GW
BW
RGW
RBW
GBW
RGBW
ð
Red
Next possible start
address for unit No. 2
38
40
43
50
55
<000-255>
address for unit No. 3
43
47
53
67
77
9
Next possible start
48
54
63
84
99
Advertisement
Chapters
Table of Contents
