Emerson USB Fieldbus Interface User Manual page 47

January 2019
7.3 Cannot edit device parameters in FDT Frame Application
Figure 7-4:
• Check the Node ID in PACTware and the Device Address in the USB
Fieldbus Interface Configuration utility. The Node ID and Device Address
should match. You may need to manually enter the Node ID in PACTware.
For more information on entering the Node ID, see
• Update the DTM library. If a new DTM is added, you may need to update
the DTM library. For more information, see
• Check physical connections. Make sure all devices are properly connected
and have access to a power source. For more information, see
• Commission the fieldbus device. For more information, see
Cannot edit device parameters in PACTware
Section 6.3.
Section 6.2.
Section
User's Manual
Section 3.5.
4.4.
47