Powering Up The Terminal; Terminal On/Off Switch; Power Button Override - NCR RealPOS 72XRT POS User Manual

Installing the Terminal

Powering Up the Terminal

Terminal On/Off Switch

The Terminal On/Off Switch is located on the Front Base Cover. This is a logic switch
only and does not remove power to the system.
After AC power is applied, it can take several seconds for the unit to respond when the
Terminal On/Off Switch is pressed. If the unit does not power on, wait several more
seconds and press the Terminal On/Off Switch again.

Power Button Override

When the Power Button is held for five seconds the system shuts down immediately.
This function can be disabled in the BIOS. In the Boot Menu set the Power Button
Override option to Disabled.
After power is applied to the terminal the Power-up self-tests run to verify basic
functionality. ROM-based setup should be used to configure network options. Full
configuration depends upon the system server and the management web site.
2-57