Cursor Position (10H, Position); Reset (13H) - NCR RealPOS 72XRT POS User Manual

9-130

Cursor Position (10h, POSITION)

This command sets the cursor position. The POSITION byte moves the cursor position
according to the table below. The next character byte writes to the new position and the
cursor auto-increments to the next position. This command is ignored if the POSITION
byte value is greater than 27h.
This command resets the module to the following conditions:
1 2 3 4 5
1 00h 01h 02h 03h
2 14h 15h 16h 17h

Reset (13h)

• 100% luminance
• All 5x8 dot matrix characters set to 20h (space)
• Cursor position set to 00h
• Character table set to Table 1
• All user defined characters cleared
6 7 8 9
04h 05h 06h 07h
18h 19h 1Ah 1Bh
10 11 12 13
08h 09h 0Ah 0Bh
1Ch 1Dh 1Eh 1Fh
2x20 Customer Display Interface
14 15 16 17 18
0Ch 0Dh 0Eh 0Fh
20h 21h 22h 23h
19 20
10h 11h 12h 13h
24h 25h 26h 27h