Table of Contents
Advertisement
Switch S5 should be 1 if you are connecting to the BNC connector:
Switch S5 should be 0 if you are connecting to the 10BASE-T connector:
Set all other switches to CLOSED.
Turn ON power to the HP E3472A/73A Emulator.
3
Wait at least 20 seconds for the HP E3472A/73A Emulator to connect
4
to the LAN.
Become the root user on the system from which you wish to
5
configure the HP E3472A/73A Emulator.
Enter the following command:
6
ipconfig700 -l <link> -i <internet> [-g <gateway>]
The ipconfig700 parameters are:
The link-level address. Enter any letters in the address in upper case.
-l <link>
The IP address.
-i <internet>
The gateway address.
-g <gateway>
If the ipconfig700 command is entered without any options, the program
interactively prompts for the necessary information.
Disconnect the power cable from the emulation controller. Set
7
switch S6 back to CLOSED and connect the power cable again.
Verify your HP E3472A/73A Emulator is now active and on the
8
network. See "To verify LAN communications" in this chapter.
Connecting to the Host Computer
To configure LAN parameters using "ipconfig700"
27
Advertisement
Table of Contents
