Table of Contents
Advertisement
To verify serial communications
Start a terminal emulator program on the host computer.
1
If you are using a PC, the Terminal application (HyperTerminal) in Microsoft
Windows 95 will work fine.
If you are using a UNIX workstation, you can use a terminal emulator such as
kermit.
Plug the power cord into the HP E3472A/73A Emulator.
2
When the HP E3472A/73A Emulator powers up, it sends a message (similar
to the one that follows) to the serial port and then displays a prompt:
Copyright (c) Hewlett-Packard Co. 1987
All Rights Reserved.
Reproduction, adaptation, or translation without prior
written permission is prohibited, except as allowed under copyright laws.
HPE3499B Series Emulation System
Version:
A.07.00 17Aug96
Location:
Generics
HPE3472A Hitachi SH7040 Series Emulator
Version:
A.00.00 17Aug96 17:07
Speed:
33.3 MHz
Memory:
0 KBytes
PC Board:
f200-00e0-0000-78ff
R>
The version numbers may be different for your HP E3472A/73A Emulator.
Press the Return or Enter key a few times.
3
You should see a prompt such as "R>", "p>" or "c>".
See Also
"Problems with the Serial Interface" in Chapter 10.
Connecting to the Host Computer
To verify serial communications
37
Advertisement
Table of Contents
