Connecting The Logic Analyzer - HP E3473A User Manual

Connecting the Logic Analyzer

Follow the steps below to connect the logic analyzer to the HP E3472A/73A
Emulator.
Disconnect the power source from the HP E3472A/73A Emulator
1
Switch off the target system.
2
Connect the logic analyzer to the host computer via a LAN.
3
Enter the Configuration Screen of the logic analyzer to specify LAN
parameters. See LAN User's Guide that comes with the logic analyzer
for detail.
N o t e
If you specified the IP address for the logic analyzer when you installed
HP B3755A/56A Debug User Interface, giving the same address will skip the
addressing operation when you start the Debugger.
Connect the pods via the termination adaptors into the emulation
4
probe.
Connect the appropriate pods into the emulation probe according to the label
("POD 1", "POD 2", ..., "POD 5") on it. See Figure 7-1 and Table 7-1 to find the
connection mapping for your logic analyzer.
Figure 7-1. Connecting the Pod
Using the Logic Analyzer
Connecting the Logic Analyzer
51