HP E3473A User Manual page 35

Connecting to the Host Computer
Connecting to the Host Computer
To use the HP E3472A/73A Emulator you need to:
•
Connect the HP E3472A/73A Emulator to the target system
(described in the next chapter)
•
Connect the HP E3472A/73A Emulator to a power source. See
"Assembling the Emulator" for the connection procedure.
•
Power on the target system
•
Connect the HP E3472A/73A Emulator to the host computer via a
LAN
•
Set up the host software
If you plan to use the HP E3472A/73A on a PC, you will need to set up
a serial connection to set the IP address for LAN.
As a debugger controlling the Emulator, you can use the
HP E3755A/56A Debug User Interface on a UNIX workstation or a PC.
N o t e
When supplying power to the emulator, check that the emulation probe is
plugged into the target system or demo board.
20