Connecting the HP E3472A/73A Emulator to the target system
Check that the emulator and the target system are OFF.
1
Remove the processor from the target system.
2
Connect the QFP cable to the emulation probe.
3
Connect the QFP cable so that pin 1 of the QFP cable is inserted into
4
pin 1 of the QFP socket/adapter on the target system (see Figure 5-1).
Switch on the target system; then switch on the emulator.
5
Figure 5-1. Connecting HP E3472A/73A Emulator into the Target System.
Connecting to the Target System
43