Completely Resetting The Diskg; Initializing And Formatting The Diskg After A Complete Reset - iStorage diskg User Manual

18. Completely resetting the diskG

If you forget all the User PINs or Admin PINs, you can perform a complete reset to remove all the User
PINs, and restore the Admin PIN to the default 123456.
Attention:
the drive unrecoverable. You will need to partition and format the diskG with disk management
applications. To perform a complete reset of the drive, do the following:

19. Initializing and formatting the diskG after a complete reset

A complete reset of the diskG will erase all information and partition settings.
You will need to initialize and format the diskG.
To initialize your diskG, do the following:
1. After a complete reset, attach the diskG to the computer.
2. Wait 5 seconds for the computer to recognize the device.
3. Enter the default User PIN 123456 and press
4. Right-click My Computer or Computer, and then click Manage.
Completely resetting the diskG will reset the encryption key, in effect making all the data on
1. Press and hold the "Cancel" button while you attach the diskG to an
available USB port on your computer. The LED indicator light will flash
RED alternately.
Note: If no activity is detected for 30 seconds during this step, the diskG
will go into the Standby Mode.
2. Press and hold "Cancel" +
flashes RED and BLUE
LED indicator light will then turn solid
RED. You have successfully reset the diskG.
to enter the User Mode.
+ 2 for 10 seconds until the LED indicator light
intermittently, and then stops on a solid color. The
GREEN for two seconds, followed by solid
www.istorage-uk.com
BLUE and
#15