Deprag AST40-1 Operating Instruction Booklet page 28

FC_CycleDone
FC_LockPart
DataAvailable
Error
HW_FC_ErrReset
HW_FC_PartSensor
HW_FC_ReleasePart
HW_ReleaseStart
HW_Start
HW_Reload
HW_ProgIn1
HW_ProgIn2
HW_ProgIn3
HW_ProgIn4
Cycle ended for F-Function
BOOL
This signal is currently not available yet!
Lock part for F-Function
BOOL
This signal is currently not available yet!
Data is available
This signal indicates that new screw data is available.
BOOL This is reset by the AST40 sequence controller, if the
signal "Data Saved" is set by the SPS program or a new
screwdriving sequence is started.
Error
This signal indicates that an error has occurred in the FB13
BOOL
module. The detailed error code is given in the "ErrorCode"
parameter.
Error Reset for F-Function (hardware interface)
This signal indicates the status of the Reset signal at the
BOOL
hardware interface.
(see 6.2.7 I/O
Parts sensor for F-function (hardware interface)
This signal indicates the status of the "Parts sensor" signal
BOOL
at the hardware interface.
(see 6.2.7 I/O
Part release for F-Function (hardware interface)
This signal indicates the status of the "Part release" signal
BOOL
at the hardware interface.
(see 6.2.7 I/O
Clearance to start (hardware interface)
This signal indicates the status of the "Start approval"
BOOL
signal at the hardware interface.
(see 6.2.7 I/O
Start signal (Hardware interface)
This signal indicates the status of the start signal at the
BOOL
hardware interface.
(see 6.2.7 I/O
Reload signal (hardware interface)
This signal indicates the status of the Reload signal at the
BOOL
hardware interface.
(see 6.2.7 I/O
Input 1 for the screwdriver program (Hardware
interface)
BOOL
This signal indicates the status of input 1 at the hardware
interface.
(see 6.2.7 I/O
Input 2 for the screwdriver program (Hardware
interface)
BOOL
This signal indicates the status of input 2 at the hardware
interface.
(see 6.2.7 I/O
Input 3 for the screwdriver program (Hardware
interface)
BOOL
This signal indicates the status of input 3 at the hardware
interface.
(see 6.2.7 I/O interfaces)
BOOL
Input 4 for the screwdriver program (Hardware
28
interfaces)
interfaces)
interfaces)
interfaces)
interfaces)
interfaces)
interfaces)
interfaces)