Deprag AST40-1 Operating Instruction Booklet page 148

Profinet
Program selection
Proxy
PU
Push to start
Ready signal
Reload
Resolver
Screwdriver logic
Screwdriving program
Screwdriving sequence
Screwdriving strategy
Sequence controller
Standard deviations
Stationary screwdriver
Switching off criteria
Toolbox
Web interface
Industry bus for the control and data exchange with sequence
control resp. the base station
Selection of the program to be started. The program selection can
occur in different ways, depending on control and selected screw
types (e.g. I/O interface at the control, direct program switching at
the screwdriver, etc.)
Communication interface in a network.
see power unit
The screwdriver starts as soon as the bit is pushed.
The ready signal indicates that the control is ready for the start of a
screw assembly. If the ready signal is not available then either a
screw assembly is active or a state is present that prevents the
screw assembly (certain menus, system error).
Functionality for the control of screw feeders directly via the
sequence controller
electro-magnetic transducer to change the angle position of a rotor
in an electric size
Electronic where all data of the screwdriver is stored. If the
screwdriver is connected to the controller then it recognizes all data
of the screwdriver. No settings have to be performed manually.
Sequence of the screwdriving process
Consists of screwdriving strategies and commands
Sequence of the screwdriving process
Consists of screwdriving strategies and commands
Implementation of common screwdriving processes with pre-
defined parameters which contain the precise value of a screw
assembly. (e.g. fasten to torque with rotational angle control)
Controller to use with the EC or EC servo screwdriver
Mean deviation of measuring values from the mean value.
n
 

2

x x
i
 
1
i
s

1
n
Screwdriver for stationary use
Criteria to which the screw assembly should be done (e.g. torque,
angle etc.).
Accessories for the automatic selection of a certain screwdriving
program based on the used tool.
Software interface for the programming of the sequence controller
that is actuated via a standard Internet browser.
148