checked: 19.04.89
ET46/fa
7.
Moditication ot the factory—set parameters
7.1 Keyboaxd operation
In order to change the parameters,
activates
braking)
the „PRG" key, the inverter is switched to the program mode. The
tunction code is displayed in the twa lett segments. By pressing
the „SHIFT" key the desired tunction code can be selected. After
this, the data code can be chosen using the keys marked
and
lt
„
7
„.
„SET" key.
you want to change other paraxneters, select the next
lt
tunction code using the „SHIFT" key. lt all parameters are
modified as deslred, the inverter is swltched to the normal
operating mode by pressing again the „PRG" key. After re-closing
the swltch S2, the inverter operates with the new set parameters.
—
so that the display
value is the desired new parameter, press the
this
~FTFi7T71
~9I§LLILI
1~z~
SHIFT
—
MB 33.0831
GB
open the switch S2 (which
is flashing.
SET
—
—
page:
13
By pressing
1=11 ~
~1