Automatic Screen - Graco Saniforce Operation

Electro-pneumatic Control Panel Display Screens

Automatic Screen

Feedback enabled
NOTES:
• To prime a full tote for automatic operation, press
and hold the green start button to advance the ram
downwards. Before reaching the top of the tote,
the pumps will begin to pump slowly and the ram
seal will partially inflate so that an overfilled tote
will not spill over. Continue holding the start button
until the ram plate is below the top of the tote and
the automatic sequence takes over. Releasing the
button prior to the automatic sequence beginning,
will cause ram movement to cease. Press and hold
the start button to resume.
• When the partial drum setting is selected, pump
operation is delayed until the start button is
released and the ram plate is located below the rim
Icon / Field Description
Current Recipe Name of the recipe selected for unloading this tote. Clicking in this field will display a
recipe selection screen. The recipe is selected on the recipe selection screen.
Begin tote unloading at the current state of the recipe. If the recipe was stopped before
completing, the tote unloading resumes at the point where the unloading was stopped.
32
of the tote. If the ram plate is not below the rim
of the tote when the start button is released, ram
movement ceases.
• If feedback is enabled in system settings:
– The Current Job field is active. The Current Job
box logs how much material has been dispensed
since the previous job was completed.
– The Batching checkbox is active. Selecting the
Batching checkbox enables the Batch Amount
numeric field and enters the value defined in
the selected recipe Default Batch Size field.
When the specified amount has been dispensed,
the evacuation will cease and await further
instruction.
AUTO SEQUENCE
Feedback disabled
3A5416C