Programmed Edit Recording; To Check The Order Of The Programmed Track Numbers; To Change The Program Of Each Side; To Clear The Edit Program - Aiwa NSX-A707 Operating Instructions Manual

5
3,7
4,5
3,7
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
Em
The programmed edit recording will not start from a point halfway
in the tape, The tape must be recorded on from the beginning of
either side.
1
2
3
4
5
Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
[Dress CD EDIT/cHEcK t~i~em
"EDIT" and "PRGM" are displayed.
o,When '[AI" is displayed, press CD EDIT/CHECK again.
Press numbered buttons on the remote control
to designate the tape length.
"1 O to 99 minutes can be specified.
dIThe U, ~ or MULTI JOG are also available to designate
the tape length,
Tape length Tape side A (front side)
Maximum recording
time for side A
lPress DISC DIRECT PLAY
1-3 to select a disc.
Then, press numbered buttons O-9 and + 10 on
the remote control to program a track.
lExample: To select the 10th track of disc 2, press DISC
IDIRECT PLAY 2, then press +10 and O.
Remaining time Programmed
on side A
tracks
6
7
8
Repeat step 5 for the rest 01 the tracks for side A. -.
~
A track whose playing time is longer than the remaining time ~ f
cannot be programmed.
Press CD EDllT/CHECK to
select side
B
and !$H!'
program the tracks for side
B.
,;#:+
After confirming "El" on the display, repeat step 5.
',*:;
Tape side B (reverse side)
Press the REC/REC MUTE button to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press , Recording and CD play stop simultaneously,
To check the order of the programmed track numbers
Before recording, press CD EDIT/UIECK to select sicle A or B,
and press U or - repeatedly.
Disc number Track number Program number
Tape side Programmed track
numbers
To change the program of each side
Press CD EDIT/CHECK to select side A or B, and press
CLEAR to clear the program on the selected side. Then program
tracks again.
To clear the edit program
Press CLEAR twice so that "EDIT" disappears on the display.
m
Recording is inhibited if the erasure prevention tab on either side
of the tape is broken off.
ENG,L/SH
20