Radio Reception; Manual Tuning; When An Fm Stereo Broadcast Contains Noise; To Change The Am Tuning Interval - Aiwa NSX-A707 Operating Instructions Manual

1
2
~
\--- --, -_.,/
4U
MONO
TUNER
0-9,+10
BAND
SHIFT
Press TUNER BAND repeatedly to select the
desired band.
~FM— AM7
1
I
When TUNER BAND is pressed while the power is off, the
power is turned on directly.
To select a band with the remote control
Press BAND while pressing SHIFT.
Press + DOWN or ~ UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is displayed for 2 seconds.
During FM stereo reception, ((loll] is displayed.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control while pressing SHIFT
so that "MONO" appears on the display.
MO,NO
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons so that "MONO
disappears.
To
change the
AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER BAND.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, ail preset stations are
cleared. The preset stations have to be set again.
To search
for a station quickly
(Auto Search)
Keep + DOWN or ~ UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press < DOWN or ~
UP.
The Auto Search may not stop at stations with very weak
signals.
11
ENGLISH