Connecting Optional Equipment; Listening To External Sources; Line Out Jacks; Cd Digital Out (Optical) Jack - Aiwa NSX-A707 Operating Instructions Manual

- CDDIGITAL O UT
(OPTICAL)
- VIDEOIAUX
- MD
– LINE OUT
- SUPER
WOOFERS
'SURROUND
SPEAKERS
Refer to the operating instructions of the connected equipment
for details,
The connecting cords are not supplied. Obtain the necessary
connecting cords.
Consult your local Aiwa dealer for optional equipment.
.~gf*f**$8*~,&~j# *,~~,\~~*~*g~#g, i**da*Bs~&*!rneMwm,k
,-#,x,*E*f@M,@* w*#*K~Jrm#nq@R! s%wmQ~~~,www.!s!8K
VIDEO/AUX JACKS
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, MD players, VCRs, TV, etc.).
Connect the red plug to the VIDEO/AUX R jack, and the white
plug to the VIDEO/AUX L jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
as8s*a**#J:#i*,.* ?*&:* " l*.! * w&"& a -J&& #,:q,:;x%a#,8#& rw%FJ r,m,r#i*.,trJ43 :x**$!,,,.-:.?&e* A*?%=:~ s%&wJc,':,.
MD JACKS
This jack is recommended to connect with an MD player.
Use a cable with RCA phono plugs.
Connect the red plug to the MD R jack, and the white plug to the
MD L jack.
~~w fi~q~m:,g#*,J,m, ~w,*fio#m#*$,A~&$ *8.. bm%,,w##jK*-.8, s&%,%.a%t,r%-w,*..,T#a ,*~:.!ks.-.:*,,&*~m:$&$&..
W,C?3B%: ...
LINE OUT JACKS
This unit can output analog sound signal through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
with LINE IN (analog input) jacks.
Connect the red plug of a cable to LINE OUT R jack, and the
white plug to LINE OUT L jack.
Do not connect an equipment to LINE OUT jacks and VIDEO/
AUX jacks simultaneously. Otherwise, noise is generated and
malfunction occurs.
$38u$a.4?88Rtw$@cm?v"'.,8 wc4ti&*.,P'k"~mh*mzP.,*.&?E*,,.~r+-*a@v.2 '.xa#lEleE*@.e. . ..
s-' % #.m*w:-nrm.m.r&-: rJ***, r* .a
CD DIGITAL OUT (OPTICAL) JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (DAT
deck, MD recorder, etc.).
Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
*a.s.-~b%*?~z?.$e*~.K6.%r.*.&%3*Yaw8#~:sY&?&R.E&wq8%w*:e*cB%e8, bze~?wa,% :.:3,8? .w.?em%;am.%-s: m:&=i~w.:=# .*J
SURROUND SPEAKERS d JACKS
Connect optional surround speakers with the 8 ohms to 16 ohms
impedance to the jacks.
25
ENGLISH
SUPER WOOFERS 4 JACKS
Connect optional powered sub woofers with built-in-amplifiers
to the jacks.
For better FM reception, use of an outdoor antenna is
recommended.
Connect the outdoor antenna to FM 75 Q terminals.
3'
POWER
To play a equipment connected to VI DEO/AUX jacks or MD jacks
proceed as follows.
1 Press VIDEO/AUX or MD.
To riav the eaui~ment connected to VI DEO/AUX, press
VIDEO/AUX. "VIDEO appears on the display.
To dav the equipment connected to MD, press MD. "MD"
appears on the display.
2 Play the connected equipment.
To change a source name in the display
When VIDEO/AUX is pressed, "VIDEO is displayed initially, It
can be changed to "AUX or "TV.
With the power on, press POWER while pressing VIDEO/AUX.
Repeat the procedure to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as follows.
1 Press VIDEO/AUX or MD and play the equipment.
2 Presss 4+ or ~ so that the sound level becomes the same
as that of other function sources.
m
During recording, the sound level can not be adjusted.