Setting The Timer; Timer Recording; To Check The Specified Time And Source; To Cancel Timer Standby Mode Temporarily - Aiwa NSX-A707 Operating Instructions Manual

,----- _
2,3,4
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Maks sure the clock is set correctly.
Press CLOCIVTIMER twice to display 0, then
press II SET within 6 seconds.
@
is displayed and the hour flashes.
o
[m
If you press II SET after 6 seconds, another operation may
start,
Designate the hour of the timer-on time by
pressing ~ DOWN or ~ UP, then press II
SET.
Flepeat to designate the minute of the timer-on
time.
After you designate the timer-on time, one of the source names
flashes on the display.
F>ress ++ DOWN Or ~ UP to select a source,
then press 1[ SET.
If TUNER is selected, the band cannot be selected in this
step.
4
5
6
Select the duration for the tilmer-activated Iperiod
f
with * DOWN or - UP, then press II SET, ~
The duration for the timer-activated period can be set between
e
5 and 240 minutes in 5-minute steps.
d
Prepare the source.
To listen to a CD, load the CD to be played first on 'tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the rad~, tune in to a station.
Press POWER to turn the unit off after adjusting
the volume andl tone.
@
remains on the display after the power is turned c)ff (timer
standby mode).
the timer-on time is reached, the unit turns on and When
begins play with the selected source
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To check the specified time and source
Press CLOClVTlME13 twice. The timer-on time, the selected
source name and the duration for the timer-activated p<?riodare
displayed for 4 seconds,
To cancel timer standby mode temporarily
Press CLOCIVTIMEFI repeatedly until @ or ~REC disappears
on the display.
To restore the timer standby mode, press CLOCK/TIMER
repeatedly to display @l or @REC,
Using the unit while the timer is set
You can use the unit [normally after setting the timer.
Before turning off thf? power, carry out step 5 to prepare the
source, and adjust the volume and tcme.
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
' MULTI JOG is also available instead of 44 and W
* ENTER is ako avai/ab/e instead of /[ SET.
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press CLOCIVTIMEIR repeatedly
until
@REC appears on the
display, then press II SET within 6 seconds. Carry out the
steps of "SETTING THE TIMER from step 2 and insert the tape
to be recorded on into deck 2 after step 5.
ENGLISH
24