Table of Contents
Advertisement
S Y S T E M M E N U
LCD CONTROL PANEL LOCKOUT
When Key Lock menu is set to ON, the LCD backlight will turn OFF after 30 seconds and the
Control Panel will lock and the display will show LOCKED*****.
Press and hold the MODE button for 5 seconds to unlock.
When Key Lock menu is set to ON1, the LCD backlight will turn OFF after 30 seconds and the
Control Panel will lock and the display will show LOCKED*****.
To unlock the Control Panel, follow these steps:
1. When locked, the display will show: LOCKED*****
2. Press UP, then the display will change to: LOCKED**** (one * disappears)
3. Press DOWN, then the display will change to: LOCKED*** (two * disappear)
4. Press UP, then the display will change to: LOCKED** (three * disappear)
5. Press DOWN, then the display will change to: LOCKED* (four * disappear)
6. Press ENTER, then the display will change to LOCKED and then become unlocked.
DMX Mode: Operating through a DMX controller gives the user the freedom to create their own
programs tailored to their own individual needs. See pages 18-21 for each mode's DMX traits.
Press the MODE button to select the DMX mode.
MENU Addressing and MENU Mode: This function will allow you to control each individual
fixture's traits with a standard DMX 512 controller.
1. To run your fixture in DMX mode press the MODE button until MENU Address is displayed
and press ENTER. "Set ADDR XXX" represents the current displayed DMX address.
2. Use the UP or DOWN buttons to select your desired DMX address, then press the ENTER
button to select your DMX Channel mode.
3.
Use the UP or DOWN button to scroll through the DMX Channel modes (1CH, 3CH, 4CH,
6CH, 9CH, 10CH, 12CH, and 13CH).
MENU Function:
No DMX Setup: This mode allows the unit to default to one of three modes if the DMX signal
is lost or interrupted.
1. Press the ENTER button to select your setting.
Press the UP or DOWN button to select one of the three options.
2.
HOLD =
the unit will hold the last state before the signal was lost.
BLACK =
if the DMX signal is lost or interrupted, the unit will automatically go
into stand by mode.
PROGRAM =
the unit will run the default internal programs.
16
Advertisement
Table of Contents
