J&M SpeedTender LC290 Operator's Manual page 16

12. Position conveyor above conveyor rest and lower to allow its full weight on the conveyor rest.
13. Tighten strap and ensure it is secured.
14. Ensure the collapsible hopper is in the down position and apply the vinyl hopper cover.
15. Slide the fuel shut-off lever to the "OFF" position. This will allow the engine to shutoff by running out of gas.
16. Turn the key to the "OFF" position.
Adjusting the Tarp Tension in Hanger Bracket
1. Fully unroll the tarp as shown on the right.
2. Remove the two bolts that hold the tarp u-joint on the
splined shaft.
3. Remove the u-joint from the splined shaft.
4. Rotate u-joint and handle three or four spline teeth.
5. NOTE: Rotate clockwise to tighten the tarp or
counterclockwise to loosen it.
6. Slide the u-joint and handle back onto the spline shaft.
7. Replace and tighten the two bolts.
Basic Scale Operations
1. Turn the scale "ON" by pressing the on/off button. The display shows "Hello" then the current weight value is displayed.
2. Press G/N to access the gross mode. (Live scale weight is displayed in the G/N weighing mode.)
3. In the gross mode, press the ZERO/CLEAR key to zero the indicator when the SpeedTender is empty.
4. After initial amount is placed on the scale, press the TARE Key. (Weight is tared off and goes into net mode, showing weight).
5. Load or unload material as needed (Shows + when loading and a – value when unloading).
6. When the display reaches the proper amount, stop loading or unloading.
7. Repeat steps 2 through 4 until complete.
NOTE: For more information, refer to the scale manual.
Basic Remote Operations
1. For instructions on pairing your remote or setting up the auto dispense feature, see the instructions decal on the inside of the scale
display box.
2. When using the optional Intercomp WC3-D remote, additional instructions can also be found in the Intercomp Operator's Manual
provided with your SpeedTender.
16
Operations
Bolts
U-Joint
Hanger
Bracket