J&M SpeedTender LC290 Operator's Manual page 15

9. Lock collapsible hopper in the up position.
10. Position the wagon or bulk seed container over the collapsible hopper.
11. Use the handheld controller or wireless remote to start the conveyor.
12. Fill the SpeedTender to desired level.
WARNING: Fill the front compartment first to help prevent the chance of flipping.
13. Run the conveyor until the collapsible hopper is empty.
14. When finished loading seed into the SpeedTender, move the wagon or bulk seed container away from conveyor.
15. Collapse the hopper to the down position and apply the vinyl hopper cover.
16. With the conveyor at a 45° angle, swing the conveyor hopper back under the tank and slide ball back into latch system. Replace both pins
on latch handles.
17. Position conveyor above the conveyor rest and lower to allow its full weight on the rest.
18. Lock down conveyor using the ratchet strap.
19. Slide the fuel shut-off lever to the "OFF" position. This will allow the engine to shutoff by running out of gas.
20. Turn the key to the "OFF" position.
Cleaning out Collapsible Hopper and Conveyor
WARNING: The SpeedTender must be hooked to the towing vehicle during loading and unloading.
1. Release strap from conveyor.
2. Start the hydraulic power unit and increase throttle speed. Allow hydraulic fluid to warm up if it is cold outside.
NOTE: Ensure collapsible hopper is in the down position.
3. Raise the conveyor out of conveyor rest using the handheld control.
CAUTION: If you are parked on an incline, the conveyor may swing freely.
not advised.
4. Rotate the conveyor to 45°.
5. Lower the conveyor so you can remove the telescoping spout from the discharge end of the conveyor.
6. Swing the collapsible hopper end out from under the SpeedTender shell.
7. Place the collapsible hopper in the up position.
8. With the discharge end lower than the collapsible hopper end, place the discharge end into a 5 gallon bucket. Using the handheld
controller, start the conveyor and run until completely empty.
Lower the collapsible hopper end back down to the ground. This will allow you to open the conveyor clean out door.
9.
CAUTION: Ensure all power is shut off before opening conveyor clean out door.
10. Place collapsible hopper in the down position
11. With the conveyor at a 45° angle, swing the conveyor hopper back under the tank and slide ball back into latch system. Replace both
pins on latch handles.
Operations
Conveyor Clean
Use of the SpeedTender on uneven ground is
Out Door
15