Table of Contents
Advertisement
If you cannot change it from the software, from the device, see [Setting Changes] >[SET
●
UP MENU F3] > [ID Deletion] of the manual and delete the ID and see [Setting Changes]
>[SETUP MENU F3] > [ID Registration] of the manual to newly create the ID with the rig
ht Reader Mode.
RD
RD is the Reader Assignment code for the cardholder. Entering the code "0", "3" a
ssigns both readers (Built-in Reader and Exit Reader) to grant access to the cardhol
der that is being registered, code "1" only assigns Reader#1 (Built-in Reader) and c
ode "2" assigns Reader#2 (Exit Reader). If you enter "1" in the RD field (Only Reade
r#1 assigned) and try to exit through Reader#2 (Exit Reader) then the LX007 gener
ates an error message ("Access Door Error") on the LCD display.
If the problem persists, please contact service center.
10
I want to access with card only, without password.
10.1
Please check reader mode set for the ID.
By changing reader mode, you can select how to authenticate when accessing.
See [Setting Changes] >[SETUP MENU F1] > [Reader 1 Mode] of the manual and select how
to authenticate when accessing.
If the problem persists, please contact service center.
I want to access with card only, without password.
p.89
Advertisement
Table of Contents
