Engine Maintenance Activities - Miller Bobcat 250 Diesel Owner's Manual

8-5.

Engine Maintenance Activities

5
3
4
3
!
Stop engine and let cool.
Oil And Fuel
1 Oil Drain Valve
2 Oil Filter
Change engine oil and filter according to en-
gine manual.
NOTICE − Close valve and valve cap before
adding oil and running engine.
Fill crankcase with new oil to full mark on dip-
stick (see Section 5-5).
3 Fuel Lines
Replace fuel lines if cracked or worn.
4 Inline Fuel Filter
Install new filter as shown.
OM-258413 Page 40
.
Complete Parts List is available at www.MillerWelds.com
7
2
5 Primary Fuel Filter
Replace filter according to engine manual.
Wipe up any spilled fuel.
Start engine, and check for fuel leaks.
!
Stop engine, tighten connections as
necessary, and wipe up fuel.
Coolant
6 Radiator Cap
7 Radiator Drain Cock (Located on bot-
tom of radiator)
Drain engine coolant according to proce-
dure in engine manual.
6
8
1
Add engine coolant as follows:
8 Water Bypass Hose
Remove water bypass hose. Add coolant to
radiator until coolant trickles out of water by-
pass hose. This ensures all air is purged
from the system.
Reinstall hose and radiator cap. Check cool-
ant level in overflow bottle.
Engine coolant is a mixture of water and
ethylene glycol base antifreeze. A solution
of 50% antifreeze and 50% water must be
used in this engine. Do not use 100% anti-
freeze or severe damage will occur.
259 707