Connecting The Battery - Miller Bobcat 250 Diesel Owner's Manual

5-4. Connecting The Battery

Tools Needed:
3/8, 1/2 in.
!
Connect negative (−) cable last.
Battery is most easily accessed through
the rear panel. Remove battery access
panel from rear panel. Connect battery,
negative cable last. Reinstall battery ac-
cess panel.
S
Do not allow the battery cables to
touch opposing terminals. When connect-
Notes
.
Complete Parts List is available at www.MillerWelds.com
ing the battery cables attach the positive
(+) cable to the positive (+) battery termin-
al first, followed by negative (−) cable to
negative (−) battery terminal.
S
Never start the engine when the
cables are loose or poorly connected to
the battery terminals.
−
+
259 707 / Ref. S-0756-D
S
Never disconnect the battery while
the engine is running.
S
Never use a quick battery charger to
start the engine.
S
Do not charge battery with Engine
Control switch On.
S
Always disconnect the negative (−)
battery cable before charging battery.
OM-258413 Page 23