Miller Bobcat 250 Diesel Owner's Manual page 47

C. Checking Throttle Solenoid
.
Complete Parts List is available at www.MillerWelds.com
1 2 3 5
4
6
5/8 in.
(16 mm)
Check for non-binding
7
movement of link with sole-
noid in energized position.
Check for non-binding
movement of link with
solenoid in deenergized
(relaxed) position.
!
Stop engine.
If the engine does not stay at idle
speed, verify the the throttle solenoid
and linkage is installed properly.
Adjusting Throttle Solenoid
1 Throttle Solenoid
2 Jam Nut
3 Solenoid Link
4 Shoulder Bolt
5 Throttle Lever
6 Solenoid Rod
7 Throttle Solenoid Mounting
Screw
Loosen jam nut, remove shoulder
bolt, and remove link from throttle
lever. Install link 5/8 in. (16 mm) on
solenoid rod. Reconnect link to
shoulder bolt and throttle lever.
Push solenoid rod into idle (ener-
gized) position and check for non-
binding lateral movement of throttle
link at throttle lever. If link binds, loos-
en solenoid mounting screws. Move
the solenoid slightly until the link
moves freely with solenoid in deen-
ergize (relaxed) and energized
positions. Tighten screws.
Tighten jam nut.
Go to Step D.
Tools Needed:
3/8, 7/16 in.
5/32 in.
259 852-A
OM-258413 Page 43