Section 5 − Installation; Installing Welder/Generator - Miller Bobcat 250 Diesel Owner's Manual

5-1. Installing Welder/Generator

Movement
Location / Airflow Clearance
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
Mounting
.
Complete Parts List is available at www.MillerWelds.com
SECTION 5 − INSTALLATION
OR
OR
18 in
(460 mm)
18 in
(460 mm)
1
OR
install2 2014−12 − Ref. 800 652 / Ref. 800 477-A / 803 274-A / 804 712
!
Do not move or operate unit
where it could tip.
!
Do not lift unit from end.
!
Do not weld on base. Welding
on base can cause fuel tank fire
or explosion. Bolt unit down
using holes provided in base.
!
Always securely fasten welder/
generator onto transport ve-
hicle or trailer and comply with
all DOT and other applicable
codes.
NOTICE − Do not install unit where air
flow is restricted or engine may over-
heat.
.
See Section 4-4 for lifting eye rat-
ing.
Mounting:
!
Do not mount unit by support-
ing the base only at the four
mounting holes. Do not use
flexible mounts. Use cross-
supports to adequately sup-
port unit and prevent damage
to base.
1 Cross-Supports
Mount unit on flat surface or use
cross-supports to support base.
.
Go to MillerWelds.com for more
information on truck installations.
OM-258413 Page 21