Table of Contents
Advertisement
BATTERY SAFETY
WARNING KEEP BATTERIES OUT OF REACH OF CHILDREN.
Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns
and potential perforation of the oesophagus.
If you suspect your child has swallowed or inserted a button battery immediately call the
24-hour Poisons Information Centre on 13 11 26 for fast, expert advice.
Examine devices and make sure the battery compartment is correctly secured, e.g.
that the screws or other mechanical fasteners are tight. DO NOT use if compartment is not secure.
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous and may be a choking hazard.
Inform others about the risk associated with button batteries and how to keep their children safe.
Remove the batteries if the remote is not going to be use for prolonged periods. This will help prevent damage from leaking
batteries. If leakage has occurred and corrosion is evident the remote will need to be replaced.
Leaking chemicals are toxic and MUST NOT be touched or ingested.
NEVER mix old and new batteries.
DO NOT immerse the remote control in any liquid, this will damage the remote control, rendering it inoperable and voiding
its warranty.
CHANGING THE BATTERIES
When the low power symbol (left) appears at the top
of the room temperature display
near to being fully discharged and are no longer able
to power the remote control properly, replacement of
batteries is now a priority.
1.
Using your fingernail or other suitable lever carefully remove
the back cover, do this by first prying the cover off using the
notch at the temperature sensor
continuing until the cover pops off.
When removing the remote control cover some
patience may be required as the cover is designed to
be not easily removed, this is to prevent easy access
NOTE
to the batteries, especially by young children.
2.
Once the cover is off remove the two screws
the plastic retaining bridge
head screw driver or equivalent and then remove the plastic
retaining bridge
N
3.
Remove the old button batteries
one at a time out from under the metal battery retainers
and into the space that was created when the plastic retaining
bridge
was removed in the previous step.
N
4.
Insert two new button batteries (CR2450)
battery retainers
O
(the side with the writing and the positive symbol) are facing
upwards.
5.
Re-fit the plastic retaining bridge
with the two screws
6.
With the batteries secured re-attach the rear cover by carefully
clipping it back into place, noting that the end with the notch in
it is at the bottom.
Noting that 0X (OK) will briefly be shown on the digital display
to confirm that the batteries have been successfully replaced.
Remember to dispose of used button batteries
immediately and safely.
IMPORTANT
.
Rinnai
I
end as a starting point, and
L
, using a small (No.0) Phillips
N
.
by carefully sliding them
P
P
ensuring that the positive " + " terminals
securing it back in place
N
.
M
REMOTE CONTROL OPERATION
the batteries are
that secure
M
,
O
, under the metal
11
L
M
N N
P
P
RHFE0800_1000_1500 OM
M
O
O
Advertisement
Table of Contents
