Agilent Technologies 93000 SOC Series Training Manual page 97

For details of the TIA measurement functions, see the Unit "Time
Interval Analyzer" on page 467.
The following table shows the key specifications of the High
Performance TIA:
Table 16 Specifications of High Performance TIA
Specification
Pin counts per front-end mod-
ule
Number of triggers input
Number of channels per TIA
instrument
Max. input frequency
Input voltage range
Signal input
Trigger (arming) input
Threshold voltage (Vth) range
Number of threshold per pin
Resolution
Input impedance:
Signal input
Trigger (arming) input
Termination voltage (Vterm)
range
Resolution
Min. pulse width:
Signal input (50 ohm)
Trigger input
Slope
Measurement mode
Range
Resolution
Trigger functions
Lesson 1 – Analog Modules
Value
7 input pins (with signal loop-back)
2 trigger pins
1 input to each TIA instrument
2 channels
1 GHz (Signal input 50 ohm)
(Characteristics)
-3 V to +7 V
-1.5 V to +2.5 V
-2 V to +6 V (|Vin - Vth| ≤ 7 V)
1
1 mV
50 ohm to termination voltage
10 kohm to ground
50 ohm to ground
-2 V to +6 V (|Vin - Vterm| ≤ 7 V)
1 mV
600 ps @single-shot (Characteristics)
700 ps (Characteristics)
Positive, Negative
Period, Frequency, Pulse Width,
Propagation Delay
-2.5 s to +2.5 s
0.8 ps @single-shot
Arm on Stop, Arm on Start, Arm Start
First
97