Agilent Technologies 93000 SOC Series Training Manual page 183

Lesson 2 – Waveform Digitizer Setup with the Analog Setup Tool
How to Set Up the Timing Generator
In the lower right-hand corner of the Hardware Settings page you
find a box labeled S
EQUENCER
Sequencer / Timing Generator Setup Box
For a High Speed Digitizer, you can specify:
The S P
•
EQUENCER ROGRAM
The S F
•
AMPLING REQUENCY
mutually dependent).
The T D
•
RIGGER ELAY
trigger pulse (there is always a minimal delay which depends on
the chosen analog module).
The I D
•
NTER ISCARD
sampling rate. If you specify, for example, a number of 1, the
digitizer would only capture every 2nd data point.
If you wish to define a new Sequencer Program, or to edit an
existing one, it is recommended to first fill in the other parameters
as you will leave the Hardware Settings page to do this.
/ T G
IMING ENERATOR
to be executed.
or S P
AMPLING ERIOD
, which means the additional delay after the
, which actually means a reduction of the
.
(these fields are
183