Agilent Technologies 93000 SOC Series Training Manual page 306

Mixed-signal training

Hide thumbs Also See for 93000 SOC Series:

Table of Contents

Lesson 2 – Setting Up the Waveform Generator

Analog Setup Tool (WGA Setup for ADC Test)

In Hardware Settings mode, the Analog Setup Tool shows for a

waveform generator the defined analog pin connections at the

right-hand side and a block diagram of the chosen core at the left-

Before making any changes, you should check which set is currently

selected, as the display only shows the settings of this set and all your

subsequent changes will be stored in this set.

To set up the AWG hardware, proceed as follows:

Choose a suitable filter from the pull-down list.

Enter the input impedance of the DUT pin. This is the impedance

which is expected by the AWG output.

Enter the desired minimal and maximal voltages at the DUT input

pin, then click C

attenuation and offset voltage. You can also specify the output

in the Output Parameter box to calculate the

Show Quick Links

Table of Contents