Navigating Hmi Menu; Start Screens - ABB Zenith ZTG 30 Operation, Maintenance And Installation Manual

—

4. Navigating HMI menu

—

4.1 Start Screens

System Overview
S1 Ok Not Ok S2
S1 Connected to Load
—
Fig. 4.1 From System Overview screen you will find
Switch status and Supply info views, and by pressing Up
and Down -keys (2), you can go forward to see Voltages
and Synchronization view, see the table below.
Start screens
System Overview (Switch status)
Shows voltages and frequencies of both supplies
and the switch position.
Supply info view
Shows Phase to Phase voltages of both supplies
and the frequencies.
Voltages (S1)
S1 phase voltages
S1 line voltage
Voltages (S2)
S2 phase voltages
S2 line voltage
Synchronization view
Enabled only when In-phase monitor is on.
Show the time to next sync, sync period
Current view
Enabled only when current measurement module is
connected.
Phase currents
Neutral current
Residual current
G
11:06
Active Power view
Enabled only when current measurement module is
connected.
Reactive Power view
Enabled only when current measurement module is
connected.
Apparent Power view
Enabled only when current measurement module is
connected.
Energy Counters view
Enabled only when current measurement module is
connected.
Voltages (S1)
U1 - - - U12 - - -
U2 - - - U23 - - -
U3 - - - U31 - - -
U0 - - -
Active power by phase
Total active power
Reactive power by phase
Total reactive power
Apparent power by phase
Total apparent power
Active energy by source
Reactive energy by source
Apparent energy by phase
Total active energy
Total reactive energy
Total apparent energy
39
G
11:06