Mounting Of The Hmi, Automatic Mode - ABB Zenith ZTG 30 Operation, Maintenance And Installation Manual

104
Z e n i t h Z T G S e r i e s AT S , O P E R AT I O N , M A I N T E N A N C E , A N D I N S TA L L AT I O N G U I D E
9.5.2 Mounting of the HMI,
automatic mode
2
1
Notice
When the slide switch is moved to the AUTO
position, the ATS is functioning immediately
in the automatic control mode.
—
Fig. 9.3 Before moving to the Automatic mode, the
operating handle must set to its place. When the handle
is in its place properly, the slide switch will move to the
Locking mode automatically and the switch is allowed
to be padlocked, if needed. From the Locking mode the
slide switch can be moved to the Automatic mode
3
Automatic
mode