Lifting And Mounting The Panel - ABB Zenith ZTG 30 Operation, Maintenance And Installation Manual

—

9.3 Lifting and Mounting the Panel

Lifting guidelines
Adequate lifting means must be used to
mount the transfer switch into place. The
recommended method for moving the
ATS, up to 1200A, is with lifting strap and
lifting equipment rated for the equipment
weight.
Lifting, Mounting and Installation
The safe operation of your switch at all
times is paramount to ABB. Please recog-
nize that hazardous voltages and currents
can exist during normal operation, and
any maintenance on the transfer switch
must be performed utilizing appropriate
safety measures. Installation, adjustment,
maintenance or removal of the switch
must only be carried out by qualified per-
sonnel and with all power to the switch
turned off. It is recommended that only
qualified electricians be allowed to install
or provide maintenance on the switch.
Prior to installation, store the transfer
switch in a clean dry location, protected
from dirt and water. Provide ample air cir-
culation and heat if necessary to prevent
condensation. See table 7.1 for recom-
mended storage and ambient operating
temperatures.
ABB Zenith automatic transfer switches
are packaged as per the standard packag-
ing regulatory standards requirement
suitable for domestic and international
shipment through all modes of transpor-
tation (air, sea and road). Once you un-
pack the units, please make sure all the
components are received as per the BOM.
For any missing items, contact your local
ABB Zenith service representative.
Danger
Hazardous Voltage can Cause Severe
Injury or Death
Turn OFF all power before installation,
adjustment, or removal of transfer switch
or any of its components.
Warning
Due to hazardous voltages and currents, ABB
recommends that an ABB Certified technician
or a qualified electrician perform the installa-
tion & maintenance of the switch.
Danger
Hazardous Voltage can Cause Severe
Injury or Death
Automatic Transfer Switch Equipment must
be electrically grounded. Failure to do so may
result in malfunction of the switch and possi-
ble damage to surrounding equipment.
Warning
Before drilling conduit entry holes or any ac-
cessory mounting holes, cover and protect
the switch and control panel to prevent dirt
and metal fragments from entering the me-
chanical and electrical components.
101