Using Ekip Programming -Module; Led Indications - ABB Zenith ZTG 30 Operation, Maintenance And Installation Manual

Automatic transfer switches
Table of Contents

Advertisement

56
Z e n i t h Z T G S e r i e s AT S , O P E R AT I O N , M A I N T E N A N C E , A N D I N S TA L L AT I O N G U I D E

5.3 Using Ekip Programming -module

The Ekip Programming -module is suit-
able to use with all ZTG(D) 30-1200 A, 200-
480 Vac automatic transfer switches. You
can connect the module via the program-
ming port, see Fig. 5.6. The programming
port is only compatible for use with Ekip
Programming and Ekip Bluetooth
-modules.
Ekip Programming -module allows you to:
• With Ekip Connect software update the
software and load, set and read the pa-
rameters
Fig. 5.5 Ekip Programming -module
The Ekip Programming -module draws its
power from the PC and connects one side
directly to the programming port (see Fig.
5.6) and on the other to the USB port of
the PC with the cable supplied.
Notice
Ekip Programming only powers the controller
board (HMI and external modules excluded).
Therefore, in order to identify all connected
parts with Ekip Connect, the auxiliary power
supply module, type OXEA1, must be used
(see chapter 5.4).

5.3.1 LED indications

Ekip Programming -module turns on after
connecting to the PC, and is equipped
with two LEDs. The first, illuminates
green indicating that the module is on,
and the second, illuminates yellow indi-
cating active communication.
Fig. 5.6 Programming port (USB port) is
situated in the front of the HMI, on left side

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents