ABB Zenith ZTG 30 Operation, Maintenance And Installation Manual page 64

64
Z e n i t h Z T G S e r i e s AT S , O P E R AT I O N , M A I N T E N A N C E , A N D I N S TA L L AT I O N G U I D E
5.6.1.3 Access from the display /
Ekip Com Modbus RTU –module
With modules connected and energized
the presence of the modules on the mod-
ule slot activates additional menus on the
display. The following table illustrates the
path for accessing the configuration pa-
rameters of the modules from the display:
Settings (*Default value)
:
Modules (Optional modules)
Ekip Com Modbus RTU
Serial address
Baudrate
Physical protocol
:
—
Table 5.7 The path for accessing the configuration parameters of the Ekip Com Modbus RTU -module from the display
The following table illustrates the path
from the display for accessing informa-
tion on the module:
About
:
Modules (Optional modules)
Ekip Com Modbus RTU
SN
Version
:
—
Table 5.8 Information of Ekip Com Modbus RTU -module in HMI
1... 247, default 247*
9600 bit/s, 19200 bit/s*,
38400 bit/s
8.E,1*, 8.O,1, 8.N,2, 8.N,1
Description
Address to be assigned to the modules.
NOTE: devices connected to the same network
must have different addresses
Data transmission speed
8.E,1 = 8 data bits, 1 EVEN parity bit, 1 STOP bit
8.O,1 = 8 data bits, 1 ODD parity bit, 1 STOP bit
8.N,2 = 8 data bits, no parity bit, 2 STOP bits
8.N,1 = 8 data bits, no parity bit, 1 STOP bit
Description
Serial number
Software version